Q1: More guidance on what module you reset in NCS expertĪ1: The RDC module needs to be reset using “SG-RESET”. ![]() ![]() Once reset, start to drive and the car will initialize the module and after a short drive (2 blocks for me) the OBC/CIC will give the check tire pressure message and allow a full reset of the TPMS system. Once the Module (SG-reset) is initialized you will be able to reset the TPMS/RDC in the CIC or on the OBC and read the module in NCSexpert. You must do a SG-Reset and then the car will be able to communicate with it. When you replace the module NCSexpert will not be able to communicate with it. If you have a RDC module go bad and just swap the module for a new one, the car will not communicate with the module and stay deactivated with the warnings on the dash and if you have it, in the CIC. BMW E90/ E92 /E93 RDC Module does need to be set to the car when replaced and can be done with NCSexpertand D-can cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |